Just got the first part of the center plate cut out and drilled from 0.060" Aluminum stock. Not sure that is going to be great for radio reception or FPV, but I'll get something better later. Going to try to make this a V-tail Y4 copter, I think...at least first. That skips the need for a rear servo for yaw. Similar to this basic config, anyway. MultiWii copter V-tail does better control, but that isn't airframe specific.
Friday, December 16, 2011
Start of new tri-copter
Just got the first part of the center plate cut out and drilled from 0.060" Aluminum stock. Not sure that is going to be great for radio reception or FPV, but I'll get something better later. Going to try to make this a V-tail Y4 copter, I think...at least first. That skips the need for a rear servo for yaw. Similar to this basic config, anyway. MultiWii copter V-tail does better control, but that isn't airframe specific.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.